WDI’s strand compaction technique HiPac sets the standards for gentle yet highly effective compaction of strands. Constant re-search on the parameters of strand compaction have led to the development of WDI’s.

HiPac compaction technique. HiPac compromises for highest compaction grades on one hand and most gentle treatment of the wire’s metal structure on the other hand. As a result, HiPac compaction provides highest breaking forces with least possible impact on bending fatigue, adding several benefits to PYTHON wire rope.

uncompacted
HiPac compaction

Less wear and tear

The increased contact area to drum and sheaves of the compacted strand significantly reduces wear in comparison to the uncompacted strand. While the uncompacted strand has a point contact to the sheave, the contact area of the compacted strand is much higher. This results in reduced wear and tear and increased service life of both rope and system components.

small contact area:
high contact point bearing pressure

larger contact area:
reduced bearing pressure

Multi-layer drums

In multi layer systems, uncompacted wire rope causes interlocking of wires of two neighbouring wraps in the crossover zones on the drum. Interlocking is often accompanied by audible crackling and in severe cases, flying sparks can be observed. This leads to accelerated failure of the outer wires, reason for early discard of the rope.

HiPac compaction gives our ropes a smooth surface of each strand. Interlocking and hence the destruction of the outer wires is reduced effectively, elevating the rope’s service life to a more economic level.

higher wear through friction
or wire interlocking

smooth surface
less wire interlocking

Proper Spooling pattern

The rope’s low possibility to ovalisation and diameter reduction in service provide a very uniform spooling pattern, the most important requirement for Lebus multi layer systems to work correctly. HiPac enabled PYTHON ropes have proven to spool properly even with a high number of layers.

distorted spooling pattern
uniform spooling pattern
with HiPac